51 from 56
18
Change of location
The turntable automatically recognises a change of location through the built-in GPS receiver
1)
. After a
minor
change of location the turntable moves to the last selected position and so quickly finds the satellite again.
After a
more major
change of location the turntable looks for the satellite on the basis of the GPS data of the
new location
1)
.
The following message appears while the turntable is moving:
As soon as the turntable has found the right satellite it saves its position so that it can find it more
quickly next time it starts up. The alignment of the turntable is then optimised automatically for the
best signal reception (fine adjustment). The picture can freeze temporarily while this is being done.
If the search is unsuccessful, the following message appears:
1)
The prerequisite for reception of the GPS data is correct wiring; see 5.6.9, p.25.
19
Park
You have the following options to "park" the antenna in the park position:
● Press twice the
button (on the remote control or the set).
● Press
(green button). Select with the
buttons "Move CAP to park position" and confirm with the
button.
● Switch the ignition on. The antenna and automatically moves to the park position. Prerequisite: The
green core of the power supply cable is connected to the ignition and the turntable to the supply volt-
age (see the connection diagram). Refer to the detailed instructions for this in the CAP unit installation
manual.
The following message appears while the antenna is moving into the park position:
