23 from 56
So as to prevent the receiver slipping or falling, the
installation kit can also be attached to the under-
side of the receiver. Assembly is the same as for
suspended installation, except that the mounting
kit is attached to the underside of the receiver.
5.6.5
Installation on a fixed flat surface
5.6.6
Laying the cables and connecting the turntable
5.6.7
Installation of the UFS 946/CI+
• Lay the master coaxial cable (marked red) to the UFS 946/CI+ and the second coaxial cable to the sec
-
ond receiver. If you are not using a second receiver, we recommend that you lay the second coaxial cable
in any case, so that it is available should you ever need it.
• Lay the turntable power supply cable (3-pin plug) to the battery.
Avoid laying the cables across sharp edges and protect the cables against possible chafing
points.
• Connect the master coaxial cable (coming from the turntable) to the “IF IN” F socket on the rear of the
UFS 946/CI+.
• Place the infra-red sensor for the receiver close to or directly on top of the TV set and lay the cable to the
UFS 946/CI+. Connect the 6-pin Western connector at the rear to the socket marked “IR REMOTE IN”
(see also 5.6.9, p.25).
• Connect the receiver and the TV set with the HDMI cable
1)
. Plug the HDMI cable into each set at the
"HDMI" socket.
1)
The HDMI cable is included with the receiver.
Isolate the on-board power supply (master switch “off” or disconnect the positive pole of the on-board power
supply battery) before commencing the following work:
● Connect the power cable supplied (depending on the power supply available in your motor home or car
-
avan, either a 12 V supply or a 230 V supply via a power supply unit) to the "
" socket on the
receiver.
Make sure that the “inline” integrated fuse (5 A) of the cable is fully plugged in and is intact. If the fuse
blows, the source of the fault must first be eliminated. The fuse may only ever be replaced by a fuse with
the same rating (5 A).
Important
The receiver may not be connected to any other power supply than 12 V. The receiver’s earth con
-
nection must be connected to the negative pole of the motor home or caravan battery.
