Kasei KZ-4000MT-PRO-2S, Owner'S/Operator'S Manual

Page: 23 / 118

16
●
Keep in mind that the operator is responsible for accidents or hazards occuring to other people or
their property.
Safety instructions while working
●
Always ensure you have a safe and stable working position.
●
Always use both hands to hold the machine. Hold the machine at the side of your body.
●
Use your right hand to control the throttle setting.
●
Make sure that your hands and feet do not come near the cutting attachment when the engine is
running.
●
When the engine is switched off, keep your hands and feet away from the cutting attachment until
it has stopped completely.
●
Watch out for stumps of branches that can be thrown out during cutting.
●
Always lay the machine on the ground when you are not using it.
●
Do not cut too close to the ground. Stones and other objects can be thrown out.
●
Check the working area for foreign objects such as electricity cables, insects and animals, etc, or
other objects that could damage the cutting attachment, such as metal items.
●
If any foreign object is hit or if vibrations occur stop the machine immediately. Disconnect the
connection between the ignition coil and spark plug from the spark plug. Check that the machine is
not damaged. Repair any damage.
●
If anything jams in the blades while you are working, switch off the engine and wait until it has
stopped completely before cleaning the blades. Disconnect the connection between the ignition coil
and spark plug from the spark plug.
●
Never put the machine down with the engine running unless you have it in clear sight.
●
This machine is not electrically insulated. If the machine touches or comes close to high-voltage
power lines it could lead to death or serious bodily injury. Electricity can jump from one point to
another by arcing. The higher the voltage, the greater the distance electricity can jump. Electricity can
also travel through branches and other objects, especially if they are wet. Always keep a distance of at
least 10 m between the machine and high-voltage power lines and/or any objects that are touching
them. If have to work within this safe distance you should always contact the relevant power company
to make sure the power is switched off before you start work.