Kasei KZ-4000MT-PRO-2S, Owner'S/Operator'S Manual

Page: 37 / 118

28
SAFETY RULES & PRECAUTIONS
Proper and safety precautions must be observed. Like all power equipment this unit must be
handled carefully. DO NOT EXPOSE YOURSELF OR OTHERS TO DANGER Follow these
general rules. Do not permit others to use this machine unless they are thoroughly responsible and
have read, and understand the machine manual and are trained in its operation.
Always wear safety goggles for eye protection. Dress properly , do not
wear loose clothing or jewelry that could become caught in moving parts of the unit. Safe, sturdy,
nonskid footwear should always be worn. Long hair should be tied back. It is recommended that
legs and feet be covered to protect from flying debris during operation.
Inspect the entire machine for loose parts (nuts, bolts, screws, etc.) and any damage. Repair or
replace as necessary before using the machine.
DO NOT USE any attachment with this power head other than the ones recommended by our
company. Serious injury to the operator or bystanders could result as well as damage to the
machine.
Keep the handles free from oil and fuel.
Always use proper handles and shoulder strap when cutting.
Do not smoke while mixing fuel or filling tank.
Do not mix fuel in an enclosed room or near open flames. Assure adequate ventilation.
Always mix and store the fuel in a properly marked container that is approved by local codes
and ordinances for such usage.
Never remove the fuel tank cap while the engine is running.
It is essential to keep the machine in good working condition, as well as the cutting attachment
and the cutting attachment guard.
Never use of non-conformant replacement components, or the removal or modification of safety
components.
Never start or run the machine inside a closed room or building. Fumes from the exhaust
contain dangerous carbon monoxide.
Never attempt to make engine adjustments while the unit is running and strapped to the operator.
Always make engine adjustments with the unit resting on a flat, clear surface.