Kaisai KMK-60RY1, Service Manual

Page: 79 / 114

M thermal Split
76 202004
Midea
M t
her
ma
l S
pli
t Ser
vice M
anual
4.17 P3 Troubleshooting
Digital display output 4.17.1
Description 4.17.2

Compressor current protection.

When the compressor current rises above the protection value (6kW models 18A, 8/10kW model 19A,
12/14/16kW single phase model 30A, 12/14/16kW three phase model 14A,), the system displays P3 protection and
Split stops running. When the current returns to the normal range, P3 is removed and normal operation resumes.

Error code is displayed on refrigerant system main PCB and user interface.
Possible causes 4.17.3

Poor condenser heat exchange.

High pressure side blockage.

Inverter module damaged.

Compressor damaged.

Outdoor unit main PCB damaged.
Midea CAC Confidential
M thermal Split
202004 77
Procedure 4.17.4
P3
No
The condenser heat exchange is poor
1
Yes
Inspect the system and fix the error
No
The high pressure side is blocked, caused
by crushed or bent pipe or blocked EXV
2
Yes
Inspect the system and fix the error
No
Inverter module has short-circuited
3
Yes
Replace the inverter module
No
Compressor has malfunctioned
4
Yes
Replace the compressor
No
Replace outdoor main PCB
Notes:
1. In heating mode check water side heat exchanger, water piping, circulator pumps and water flow switch for dirt/blockages. In cooling mode check air side
heat exchanger, fan and air outlets for dirt/blockages.
2. High pressure side blockage causes discharge temperature to be higher than normal, discharge pressure to be higher than normal and suction pressure to
be lower than normal.
3. Set a multi-meter to buzzer mode and test any two terminals of P N and U V W of the inverter module. If the buzzer sounds, the inverter module has
short-circuited.
4. The normal resistances of the inverter compressor are 0.7-1.5Ω among U V W and infinite between each of U V W and ground. If any of the resistances
differ from these specifications, the compressor has malfunctioned.
Midea CAC Confidential
Split