Just Motion Control iHSS86 Series, User Manual

Page: 5 / 28

- 5 -
Content
1
P
Introduction ............................. 6Fehler! Textmarke nicht definiert.
2
P
Features............................................................................................ - 7 -
3
P
Ports ...................................................................................................... 7
3.1 ALM and PED signal output port ................................................... - 8 -
3.2 Control signal input port ............. Fehler! Textmarke nicht definiert.
3.3 Power port ................................................................................... - 10 -
4
P
Technological Index ...................................................................... - 11 -
5
P
Connections to Control Signal ....................................................... - 12 -
5.1 Control signalSingle terminal common anode wiring ................. - 12 -
5.2 Control signal single terminal cocathode wiring .......................... - 13 -
5.3 Control signal differential wiring mode ........................................ - 14 -
5.4 232Parameter adjustment serial communication wiring ............... - 15 -
5.5 Control signal timing diagram ...................................................... - 16 -
6
P
Subdivision code switch settings ................................................... - 16 -
6.1 Subdivision setup...................... Fehler! Textmarke nicht definiert.
6.2 Single and double pulse setup ....................................................... - 19 -
6.3 Motor rotation direction setting .................................................... - 19 -
6.4 Pulse Interference Filter Settings ................................................ - 19 -
6.5 Directive Smooth Settings ............................................................ - 20 -
7
P
Error alarm and LED light flicker times ........................................ - 21 -
8
P
Installation Size ............................................................................. - 22 -
9
P
Parameters setup ............................................................................ - 22 -
10
P
Frequently Asked Questions and Fault Handling ........................ - 26 -
10.1 Power light is not on. ................ Fehler! Textmarke nicht definiert.
10.2 Power on red alarm light on ...... Fehler! Textmarke nicht definiert.