Juniper MEDIA FLOW CONTROLLER 2.0.4 -, Administrator'S Manual

Page: 71 / 400

Applying the Media Flow Controller License (CLI) 71
Media Flow Controller Administrator’s Guide Media Flow Controller Configuration Tasks (CLI)
Applying the Media Flow Controller License (CLI)
Media Flow Controller comes unlicensed and by default can only support 10 connections at
200Kbps each; it is a 40Mbps delivery system. Neither the number of sessions or the session
rate (
network connection parameters) is configurable without the Media Flow Controller
license.
After you install Media Flow Controller, contact Juniper Networks to obtain the Media Flow
Controller license for normal operations. You need to provide the node ID, which is the MAC
address of Eth0 interface; use show interface eth0 to find the hardware (HW MAC) address.
Based on this Juniper Networks will provide you a license key. After installing the license you
get full feature capability. See
license for CLI details.
To apply the Media Flow Controller license:
1. Install a license.
license install <license_key>
2. Delete a license
license delete <license_key>
3. View installed licenses, including expiration dates.
show licenses
Example:
test-vos (config) # show license
No licenses have been configured.
test-vos-cl65 (config) # show network
Network time out (seconds) : 60
Maximum concurrent sessions : 10
Per Session assured flow rate (Kbits/sec) : 0
Per Session Maximum bandwidth (Kbits/sec) : 200
test-vos (config) # license install LK2-MFC-413E-5N42-3EE6-4381-GLL8-CE98
test-vos (config) # show license
License 1: LK2-MFC-413E-5N42-3EE6-4381-GLL8-CE98
Feature: Media Flow Controller
Valid: yes
Start date: 2009/03/15 (ok)
End date: 2009/06/30 (ok)
Tied to MAC addr: 00:1E:C9:FF:0C:FA (ok)
Active: yes
test-vos-cl65 (config) # show network
Network time out (seconds) : 60
Maximum concurrent sessions : 5000
Per Session assured flow rate (Kbits/sec) : 0
Per Session Maximum bandwidth (Kbits/sec) : 0
test-vos-cl65 (config) #