6.
Place the DIMM module on the antistatic mat or in the electrostatic bag.
7.
Push the plastic ejectors to close the empty DIMM module slot.
Installing a M40e DIMM Module
To insert a DIMM module into the Routing Engine:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2.
Remove the DIMM module from its electrostatic bag.
3.
To open the empty DIMM slot, press the plastic ejectors open.
4.
Grasp the DIMM module by the edges, being careful not to touch any electrical
components.
5.
Pressing firmly on both ends, push the module into the slot until the ejectors return
completely to the closed position.
6.
Install the Routing Engine.
7.
You can view the the SDRAM configuration and verify the DIMM was installed correctly
by issuing the
show chassis routing-engine
command.
Figure 100: Installing the DIMM Module
Related
Documentation
M40e Routing Engine Description on page 26
•
•
Replacing a Routing Engine in an M40e Router on page 186
Replacing a Routing Engine in an M40e Router
The router can have a Routing Engine in each of the slots labeled
RE0
and
RE1
at the rear
of the chassis, as shown in Figure 101 on page 187. Each Routing Engine weighs
approximately 1.5 lb (0.7 kg).
Copyright © 2010, Juniper Networks, Inc.
186
M40e Multiservice Edge Router Hardware Guide
All manuals and user guides at all-guides.com
