Juniper JUNOSE 11.1.X MULTICAST ROUTING, Configuration Manual

Page: 47 / 270

IP and VLAN Statistics
Use the show vlan subinterface command to display statistics for a VLAN interface
configured over port 8. For more information, see
Monitoring Ethernet Interfaces in
the JUNOSe Physical Layer Configuration Guide .
Use the show ip interface command to display statistics for an IP interface configured
over port 8. For more information, see
Monitoring IP in the JUNOSe IP, IPv6, and IGP
Configuration Guide .
Multicast traffic redirected by the hardware multicast packet replication feature is
displayed in the statistics for the IP or VLAN interface over port 8, not the original
IP or VLAN interface over the physical port.
The statistics for the IP or VLAN interface over port 8 reflect the number of packets
that passed through this interface destined for the hardware multicast packet
replication hardware. These statistics have no direct correlation to the number of
packets being transmitted from any of the physical ports.
IGMP Statistics
Use the show ip igmp interface command to display statistics, including hardware
multicast packet replication configuration, for an IP interface stacked over port 8.
For more information, see “Monitoring IGMP” on page 61 in “Configuring IGMP” on
page 43.
Blocking and Limiting Multicast Traffic
You can either block mroute creation, limit the multicast bandwidth admitted on an
outgoing interface, or limit outgoing interface creation on a port.
Blocking Mroutes
By default, when an interface that is configured with one or more multicast protocols
(for example, PIM or IGMP) receives multicast traffic, even when the scope of that
traffic exceeds link-local, the virtual router creates an mroute. You can use the
ip
block-multicast-sources command to block all multicast traffic with a scope larger
than link-local (for example, global) and prevent mroute creation under these
conditions.
NOTE: Issuing this command does not affect reception of link-local multicast packets.
ip block-multicast-sources
■
Use to prevent mroute creation by blocking multicast traffic that has a scope
larger than link-local (for example, global).
■
Example
Blocking and Limiting Multicast Traffic
■ 25
Chapter 1: Configuring IPv4 Multicast