Juniper JUNOSE 11.1.X MULTICAST ROUTING, Configuration Manual

Page: 150 / 270

For information about modules that support DVMRP on the E120 and E320 Broadband
Services Routers:
■
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
■
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support DVMRP.
References
For more information about DVMRP, see the following resource:
■
Distance Vector Multicast Routing Protocol—draft-ietf-idmr-dvmrp-v3-11.txt
(April 2004 expiration)
Before You Begin
You can configure multicasting on IPv4 and IPv6 interfaces.
For information about configuring IP interfaces, see Configuring IP in the JUNOSe IP,
IPv6, and IGP Configuration Guide . For information about configuring IPv6 interfaces,
see Configuring IPv6 in the JUNOSe IP, IPv6, and IGP Configuration Guide .
For information about configuring multicast on IPv6 interfaces, see “Configuring
IPv6 Multicast” on page 147.
Enabling DVMRP on a VR
By default, DVMRP is enabled on the router. To enable DVMRP on a VR:
1.
Enable multicast routing.
host1(config)# ip multicast-routing
2.
(Optional) Create a VR or access a VR context.
host1(config)# virtual-router boston
NOTE: If you do not specify a VR, you can configure DVMRP on the default router.
You must enable and configure DVMRP on one or more interfaces for DVMRP to
function. See “Activating DVMRP on an Interface” on page 129. You can also set
DVMRP limits for the VR; see “Configuring DVMRP Limits” on page 129.
128 ■
References
JUNOSe 11.1.x Multicast Routing Configuration Guide