Juniper JUNOSE 11.1.X MULTICAST ROUTING, Configuration Manual

Page: 202 / 270

interface. However, if you configure MLD and PIM on the same interface,
PIM owns the interface.
■
Admitted bandwidth / configured admission bandwidth (in bps)
■
Number of blocked OIFs
■
QoS adjustment bandwidth (in bps)
■
Count—Number of multicast protocols on the VR
■
Example
host1:2# show ipv6 multicast protocols
Multicast protocols:
Protocol Pim
Type: Sparse
Interfaces: 1 registered, 1 owned
Registered interfaces:
ATM2/1.103 (21:2:2:22::1:2/60) owner Pim
Protocol Mld
Type: Local
Interfaces: 1000 registered, 1000 owned
Registered interfaces:
ATM2/0.131 (31:2:2:22::2:2/604) local Mld owner Mld
Admission-bandwidth 2000000/10000000 bps
QoS Adjust 2000 bps
ATM2/0.132 (31:2:2:22::2:3/60) local Mld owner Mld
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
ATM2/0.133 (31:2:2:22::2:4/60) local Mld owner Mld
Admission-bandwidth 8000000/10000000 bps, 2 Blocked OIFs
QoS Adjust 0 bps
...
Count: 2 protocols
■
See show ipv6 multicast protocols.
show ipv6 multicast protocols brief
■
Use to display a summary of information about multicast protocols enabled on
the router.
■
Field descriptions
■
Protocol—Name of the multicast protocol
■
Registered Interfaces—Number of interfaces on which the protocol is
configured.
■
Owned Interfaces—Number of interfaces that a protocol owns. If you
configure only MLD on an interface, MLD owns the interface. However, if
you configure MLD and PIM on the same interface, PIM owns the interface.
■
Type—Mode of the multicast protocol
■
For PIM—Sparse
180 ■
Monitoring IPv6 Multicast Settings
JUNOSe 11.1.x Multicast Routing Configuration Guide