Juniper JUNOSE 11.1.X MULTICAST ROUTING, Configuration Manual

Page: 247 / 270

1.
On one router, specify the other router to be a remote neighbor, and identify
the IP address of the interface on the other router that is used for the connection
to this router.
host1(config-router):boston# remote-neighbor 1001::1 sparse-mode
2.
Specify the location of the local interface whose address is used as the source
address for the PIM connection to a remote neighbor.
host1(config-router-rn):boston# update-source atm 2/1.108
3.
(Optional) Specify how often the router sends hello messages to the remote
neighbor.
host1(config-router-rn):boston# query-interval 40
4.
Repeat Steps 2 to 3 for the other router.
query-interval
■
Use to specify how often the router sends hello messages to remote neighbors.
■
Example
host1(config-router-rn)# query-interval 40
■
Use the no version to restore the default setting, 30 seconds.
■
See query-interval.
remote-neighbor
■
Use to specify a remote neighbor for PIM sparse mode.
■
Specify the IP address of the interface on the remote neighbor that PIM uses as
the source address for the connection to this router.
■
Example
host1(config-router)# remote-neighbor 1001::1 sparse-mode
■
Use the no version to remove the remote neighbor and any attributes configured
for the remote neighbor.
■
See remote-neighbor.
update-source
■
Use to specify the PIM interface whose local address is used as the source address
for the PIM connection to a remote neighbor.
■
You can use the same source address to form neighbor adjacencies with more
than one PIM remote neighbor.
■
You must use the IPv6 address of this interface when issuing the remote-neighbor
command on the remote neighbor.
■
Example
Configuring PIM Sparse Mode Remote Neighbors
■ 225
Chapter 7: Configuring PIM for IPv6 Multicast