Juniper JUNOSE 11.1.X MULTICAST ROUTING, Configuration Manual

Page: 69 / 270

Figure 6: Static and Dynamic IGMP Interfaces
You configure static IGMP interfaces by using software such as the CLI or an SNMP
application; you configure dynamic IGMP interfaces by using a profile. A profile
constitutes a set of attributes for an interface; a profile for dynamic IGMP interfaces
contains attributes for configuring all the layers in the interface.
You define a profile by using the same CLI commands that you use to configure a
static IGMP interface; however, the mode in which you use the commands differs.
Use the commands in Interface Configuration mode to configure a static IGMP
interface and in Profile Configuration mode to define a profile.
When you have defined a profile, you can apply it to an interface or a group of
interfaces. Profiles provide an efficient method of creating and managing large
numbers of dynamic interfaces. For detailed information about creating and assigning
profiles, see
Configuring Dynamic Interfaces in the JUNOSe Link Layer Configuration
Guide . When you create a profile for dynamic IGMP interfaces, specify attributes for
configuring all layers in the interface.
You use the following IGMP commands to configure a static IGMP interface. You also
use these commands to define the attributes for the IGMP layer when you create a
profile for dynamic IGMP interfaces:
Table 5: IGMP Commands
ip igmp query-max-response-time ip igmp
ip igmp robustness ip igmp access-group
ip igmp ssm-map enable ip igmp access-source-group
ip igmp ssm-map static ip igmp apply-oif-map
ip igmp query-interval ip igmp explicit-tracking
ip igmp static-exclude ip igmp group limit
ip igmp static-group ip igmp immediate-leave
Configuring Static and Dynamic IGMP Interfaces
■ 47
Chapter 2: Configuring IGMP