Juniper JUNOSE 11.1.X MULTICAST ROUTING, Configuration Manual

Page: 58 / 270

■
RPF Iif —Type and identifier for the incoming interface for the RPF route
■
#Oifs—Number of outgoing interfaces
■
Counts—Numbers of types of (S,G) pairs
■
(S,G)—Number of (S,G) entries
■
(*,G)—Number of (*,G) entries
■
Example
host1# show ip mroute summary
IP Multicast Routing Table
Group Address Source Address RPF route RPF Iif #Oifs
--------------- --------------- --------- ------------- ----
224.0.1.39 52.1.1.1 51.1.1.1/32 Register IIF 0
224.0.1.40 51.1.1.1 51.1.1.1/32 loopback1 1
Counts: 2 (S, G) entries
0 (*, G) entries
■
See show ip mroute.
show ip multicast protocols
■
Use to display information about multicast protocols enabled on the router.
■
Use the brief option to display a summary of information rather than a detailed
description.
■
Field descriptions
■
Multicast Protocols—Multicast protocols on this router
■
Protocol—Name of the multicast protocol
■
Type—Mode of the multicast protocol
■
For DVMRP—Dense
■
For PIM—Sparse, Dense, or Sparse-Dense
■
For IGMP—Local
■
Interfaces
■
registered—Number of interfaces on which the protocol is configured
■
owned—Number of interfaces that a protocol owns. If you configure
only IGMP on an interface, IGMP owns the interface. However, if you
configure IGMP and either PIM or DVMRP on the same interface, PIM
or DVMRP owns the interface.
■
Registered interfaces—Information about interfaces on which the protocol
is configured:
36 ■
Monitoring IP Multicast Settings
JUNOSe 11.1.x Multicast Routing Configuration Guide