Jungheinrich ETVC 16, Operating Instructions Manual

Page: 54 / 89

E 21
1005
.G
B
6 Fault locating operations
This chapter enables the user to locate and to remedy simple faults or the conse-
quences of operating errors. Fault locating operations should be performed in the or-
der as set out in the table below.
Z
If the fault could not be eliminated after performing the „troubleshooting procedures"„,
contact the customer service of the manufacturer since all follow-up troubleshooting
can only be performed by specially trained and qualified service staff.
Fault Possible cause Remedy
Truck does not
move Battery connector
not connected Check the battery connector, or con-
nect, if required
Master switch depressed Release the master switch
Key switch in position „0“ Switch the key switch to position „I“
Battery charge too low Check the charge condition of the
battery and recharge if required
Defective fuse Check fuses
Parking brake applied Release the parking brake
Foot switch not pressed Press foot switch
Load cannot be
raised Truck not operative Perform all remedial actions indica-
ted under fault „Truck does not mo-
ve“
Hydraulic oil level
too low Check the hydraulic oil level
Battery charge too low,
lift cut-out active Check the charge condition of the
battery and recharge if required
Defective fuse Check fuses
Load too high Comply with maximum load
(see nameplate)
E 21
1005
.G
B
6 Fault locating operations
This chapter enables the user to locate and to remedy simple faults or the conse-
quences of operating errors. Fault locating operations should be performed in the or-
der as set out in the table below.
Z
If the fault could not be eliminated after performing the „troubleshooting procedures"„,
contact the customer service of the manufacturer since all follow-up troubleshooting
can only be performed by specially trained and qualified service staff.
Fault Possible cause Remedy
Truck does not
move Battery connector
not connected Check the battery connector, or con-
nect, if required
Master switch depressed Release the master switch
Key switch in position „0“ Switch the key switch to position „I“
Battery charge too low Check the charge condition of the
battery and recharge if required
Defective fuse Check fuses
Parking brake applied Release the parking brake
Foot switch not pressed Press foot switch
Load cannot be
raised Truck not operative Perform all remedial actions indica-
ted under fault „Truck does not mo-
ve“
Hydraulic oil level
too low Check the hydraulic oil level
Battery charge too low,
lift cut-out active Check the charge condition of the
battery and recharge if required
Defective fuse Check fuses
Load too high Comply with maximum load
(see nameplate)