Jungheinrich EKS 410, Operating Instructions Manual

Page: 73 / 99

0
708
.GB
F 6
e) IG: inductive guidance trucks
Maintenance intervals
Standard =
t
W A B C
Lift
mechanism 10.1 Clean rollers, guide rollers and contact surfaces in the
mast sections and apply grease.
M
Attention: Danger of crashing!
t
10.2 Check mast attachments (bearings and retaining
screws)
t
10.3 Check lift chains and chain guide for wear, adjust and
lubricate
t
10.4 Lubricate lift chains
t
10.5 Visually inspect rollers, slide pieces and stops
t
10.6 Check forks and fork carriage for wear and damage
t
Attachments 11.1 Test operation and settings
t
11.2 Check attachment on truck and load bearing
components
t
Lubrication: 12.1 Lubricate the truck according to the lubrication schedule
t
General
Measure-
ments: 13.1 Check electrical system for frame leakage
t
13.2 Test travel speed and braking distance
t
13.3 Test lift and lowering speeds
t
13.4 Test safety devices and cutouts
t
13.5 IG: Measure the current in the guidance wire, adjust if
necessary e)
t
13.6 Check travel on the guidance wire, check maximum
deviation and adjust if necessary e)
t
13.7 Check tracking mode on the guidance wire for aisle
tracking
.
e)
t
13.8 Check wire guidance EMERGENCY STOP operatione)
t
Demon-
stration: 14.1 Test run with rated load
t
14.2 When maintenance is complete, present the truck to the
responsible person.
t
0
708
.GB
F 6
e) IG: inductive guidance trucks
Maintenance intervals
Standard =
t
W A B C
Lift
mechanism 10.1 Clean rollers, guide rollers and contact surfaces in the
mast sections and apply grease.
M
Attention: Danger of crashing!
t
10.2 Check mast attachments (bearings and retaining
screws)
t
10.3 Check lift chains and chain guide for wear, adjust and
lubricate
t
10.4 Lubricate lift chains
t
10.5 Visually inspect rollers, slide pieces and stops
t
10.6 Check forks and fork carriage for wear and damage
t
Attachments 11.1 Test operation and settings
t
11.2 Check attachment on truck and load bearing
components
t
Lubrication: 12.1 Lubricate the truck according to the lubrication schedule
t
General
Measure-
ments: 13.1 Check electrical system for frame leakage
t
13.2 Test travel speed and braking distance
t
13.3 Test lift and lowering speeds
t
13.4 Test safety devices and cutouts
t
13.5 IG: Measure the current in the guidance wire, adjust if
necessary e)
t
13.6 Check travel on the guidance wire, check maximum
deviation and adjust if necessary e)
t
13.7 Check tracking mode on the guidance wire for aisle
tracking
.
e)
t
13.8 Check wire guidance EMERGENCY STOP operatione)
t
Demon-
stration: 14.1 Test run with rated load
t
14.2 When maintenance is complete, present the truck to the
responsible person.
t