Jungheinrich EKS 410, Operating Instructions Manual

Page: 29 / 99

1
004
.GB
C 6
4 Commissioning
4.1 Moving the truck without a battery
M
This operation must only be performed by suitably trained maintenance personnel.
M
This operation is forbidden on slopes and inclines (no brakes).
See also chapter E, “Recovering the truck from a narrow aisle / Moving the truck
without a battery”.
4.2 Installing and removing the mast
M
This operation must only be performed by the manufacturer or a customer service
team authorised by the manufacturer.
5 Starting the truck for the first time
M
Operate the truck only with battery current. Rectified AC current will damage the
electronic components. The battery leads (tow cable) must be less than 6m long.
To prepare the truck after delivery or after transport, proceed as follows:
– Install and charge the battery if necessary (see Chapter D, Sections 4 and 3).
– Commission the truck as per instructions (See Chapter E, Section 3).
Z
With the EKS 410/513/515k/515 a tipover retaining device (30) is fitted, depending on
the tipover test. When a tipover retaining device is used, an X (29) is engraved on the
truck chassis on the right hand side of the battery compartment, after the serial
number.
M
Before operating, check the trucks to ensure the tilt safety devices (30) are present
(if required).
M
Check that all safety devices are present and operational.
29
30
1
004
.GB
C 6
4 Commissioning
4.1 Moving the truck without a battery
M
This operation must only be performed by suitably trained maintenance personnel.
M
This operation is forbidden on slopes and inclines (no brakes).
See also chapter E, “Recovering the truck from a narrow aisle / Moving the truck
without a battery”.
4.2 Installing and removing the mast
M
This operation must only be performed by the manufacturer or a customer service
team authorised by the manufacturer.
5 Starting the truck for the first time
M
Operate the truck only with battery current. Rectified AC current will damage the
electronic components. The battery leads (tow cable) must be less than 6m long.
To prepare the truck after delivery or after transport, proceed as follows:
– Install and charge the battery if necessary (see Chapter D, Sections 4 and 3).
– Commission the truck as per instructions (See Chapter E, Section 3).
Z
With the EKS 410/513/515k/515 a tipover retaining device (30) is fitted, depending on
the tipover test. When a tipover retaining device is used, an X (29) is engraved on the
truck chassis on the right hand side of the battery compartment, after the serial
number.
M
Before operating, check the trucks to ensure the tilt safety devices (30) are present
(if required).
M
Check that all safety devices are present and operational.
29
30