Jungheinrich EKS 410, Operating Instructions Manual

Page: 61 / 99

0
206
.GB
E 24
Abseiling
F
Do not drop into loose rope. Watch out for obstacles when abseiling.
– Make the rope (52) taut.
– Exit with your face towards the truck.
– To abseil, press the lever (51) on the abseil device down.
– To stop abseiling, release the brake lever (51).
5.4 Bypassing the chain slack safety device
If the slack chain safety device engages (the “Slack chain
override” symbol (55) appears in the display), e.g. when
the fork carriage is put in position or the lift chain becomes
loose or breaks. It is possible to “lift” the primary raise if the
override switch (56) is depressed and held down while the
hydraulic control button is pressed. “Lowering” is now
disabled.
Before starting again, rectify the damage.
Travel is inhibited whatever the position of the fork
carriage.
M
The truck may only be started again once the damage has been removed.
5.5 Bypassing the travel cutout (
o
)
If travel is inhibited from a certain lift height (the “Travel
cutout override” symbol (57) appears in the display), but
the position of the truck relative to the rack must be
adjusted to load or unload goods, press the “unlock travel”
switch (58) and apply the travel lever as described in
“Travelling”. This allows you to travel at crawl speed.
56
55
58
57
0
206
.GB
E 24
Abseiling
F
Do not drop into loose rope. Watch out for obstacles when abseiling.
– Make the rope (52) taut.
– Exit with your face towards the truck.
– To abseil, press the lever (51) on the abseil device down.
– To stop abseiling, release the brake lever (51).
5.4 Bypassing the chain slack safety device
If the slack chain safety device engages (the “Slack chain
override” symbol (55) appears in the display), e.g. when
the fork carriage is put in position or the lift chain becomes
loose or breaks. It is possible to “lift” the primary raise if the
override switch (56) is depressed and held down while the
hydraulic control button is pressed. “Lowering” is now
disabled.
Before starting again, rectify the damage.
Travel is inhibited whatever the position of the fork
carriage.
M
The truck may only be started again once the damage has been removed.
5.5 Bypassing the travel cutout (
o
)
If travel is inhibited from a certain lift height (the “Travel
cutout override” symbol (57) appears in the display), but
the position of the truck relative to the rack must be
adjusted to load or unload goods, press the “unlock travel”
switch (58) and apply the travel lever as described in
“Travelling”. This allows you to travel at crawl speed.
56
55
58
57