Jungheinrich EKS 410, Operating Instructions Manual

Page: 34 / 99

D 5
1
004
.GB
o
EKS 513 – 515 (Installing/removing batteries in the battery replacement
carriage with a forklift):
– Turn key switch (18) to "0" (zero).
– Lift up the battery panel (20).
– Pull the battery panels (21) up and lift them off.
– Remove the battery connector (23) from the left and right-hand side of the battery
compartment.
– Remove the battery retainers (22) from the left and right-hand side of the battery
compartment.
– Carefully pull out the batteries (24) from the left or right hand side using a forklift
truck. To do this, enter the forklift’s load handler into the fork shoes (25) of the
battery replacement carriage.
Assembly is the reverse order.
M
When fitting the batteries (24) in the battery replacement carriage, make sure that the
load handler of the forklift truck used for assembly is located in the fork shoes (25) of
the battery frame. In addition, the fork tips of the load handler must not project beyond
the battery replacement carriage.
F
After replacing/fitting the battery, make sure that the battery is well secured in the
battery compartment.
F
After installing again, check all cables and connectors for signs of visible damage and
before using the truck again check that:
– the battery retainers (22) are inserted and are secure,
– the battery panels (20, 21) are properly closed.
D 5
1
004
.GB
o
EKS 513 – 515 (Installing/removing batteries in the battery replacement
carriage with a forklift):
– Turn key switch (18) to "0" (zero).
– Lift up the battery panel (20).
– Pull the battery panels (21) up and lift them off.
– Remove the battery connector (23) from the left and right-hand side of the battery
compartment.
– Remove the battery retainers (22) from the left and right-hand side of the battery
compartment.
– Carefully pull out the batteries (24) from the left or right hand side using a forklift
truck. To do this, enter the forklift’s load handler into the fork shoes (25) of the
battery replacement carriage.
Assembly is the reverse order.
M
When fitting the batteries (24) in the battery replacement carriage, make sure that the
load handler of the forklift truck used for assembly is located in the fork shoes (25) of
the battery frame. In addition, the fork tips of the load handler must not project beyond
the battery replacement carriage.
F
After replacing/fitting the battery, make sure that the battery is well secured in the
battery compartment.
F
After installing again, check all cables and connectors for signs of visible damage and
before using the truck again check that:
– the battery retainers (22) are inserted and are secure,
– the battery panels (20, 21) are properly closed.