4.2 Connecting a luminaire to a transmitter
Figure 10
o
Press the
Ɔ
and
ƌ
buttons simultaneously until the LEDs flash green.
The luminaire flashes briefly. Connection in process.
LEDs on transmitter light up green. Lamp lights up green or flashes twice. Connection has
been set up successfully.
LEDs on transmitter flash red quickly for 3 seconds. Could not set up connection.
i
In case of error, the distance between the devices is too big or the luminaire already
belongs to an existing network, see chapter 4.5.
Alternatively, all memory locations in the transmitter are occupied. In this case, delete all
connections to luminaires that are no needed, see chapter 4.6.
4.3 Adding the transmitter to an existing network
i
If the transmitter already had belonged to a network, reset the transmitter, see chapter 4.7.
Figure 11
Precondition:
At least one luminaire must be switched on.
o
Press the
Ƌ
and
ƍ
buttons on the new transmitter simultaneously until the LEDs
flash green.
The new transmitter is in programming mode.
8/17
32596203
J0082596203
23.05.2016
ZigBee radio transmitter module 4-gang
