o
Switch on the service functions, see chapter 5.1.
o
Press the
Ƈ
button for longer than 4 seconds.
LEDs light up green for 3 seconds. The connections have been saved in the buffer
memory.
o
As an option, press the
Ɔ
button shortly in order to show all luminaires in the buffer
memory.
The luminaires saved in the buffer memory light up shortly.
o
Within 2 minutes, after the last button has been pressed, transfer the buffer memory to the
desired transmitter, see chapter 5.5.
5.5 Passing connections from the buffer memory to a transmitter
o
Put the receiving transmitter in programming mode, see chapter 4.3.
Figure 20
o
Start a connection process on the sending transmitter by pressing the
Ɔ
and
ƌ
buttons simultaneously until the LEDs flash green.
The connections are passed from the buffer memory to the receiving transmitter.
LEDs light up green for 3 seconds. The connections from the buffer memory are passed
on.
LEDs flash red quickly for 3 seconds. The connections from the buffer memory have not
been passed on.
6 Updating device software
The device software is updated via radio. This requires a separately available additional device.
Refer to the manual of the additional module.
Precondition 1:
The additional device must belong to the network of the transmitter.
Precondition 2:
The transmitter must not be in default.
14/17
32596203
J0082596203
23.05.2016
ZigBee radio transmitter module 4-gang
