o
Screw wall transmitter module (8) to base plate.
i
Screwing the screws too tightly could impair functions of the wall transmitter.
o
Snap on the buttons (11)(figure 22).
Information on gluing mounting
Precondition: To be able to fasten the wall transmitter safely, the surface must be flat and free
of dust and grease.
o
Remove the rear, unpunched film of the enclosed adhesive pad.
o
Align the adhesive pad, stick it to the surface and smooth it out. Remove air bubbles.
o
Remove the two inner segments of the front film.
o
Align the base plate to the external punching and stick it on.
i
In the case of multiple combinations, the abutting sides of the adhesive pads must be cut
along the external punching using a ruler and a cutter (figure 23).
Figure 23: Cutting the adhesive pads for multiple combinations
i
If necessary, after mounting the wall transmitter in the CD program, carefully remove the
excess adhesive film in the corners.
8 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
8.1 Technical data
Rated voltage
DC 3 V
Battery type
1×Lithium CR 2450N
Ambient temperature
-5 ... +45 °C
Relative humidity
max. 80 % (No moisture condensation)
Storage/transport temperature
-25 ... +70 °C
Degree of protection
IP 20
Protection class
III
Number of connections
max. 10
Transmitting range in free field
typ. 100 m
Radio frequency
2.400 ... 2.483 GHz
Transmission capacity
< 10 mW
16/17
32596203
J0082596203
23.05.2016
ZigBee radio transmitter module 4-gang
