Jung LB management, Manual

Page: 181 / 196

OPERATION 181
YOU WOULD LIKE TO... IMPLEMENTATION FURTHER INFORMATION
... switch on the light /
move the blinds up. − Press the right arrow button. If the dimming insert is used, the light is switched
to the saved switch-on brightness.
... switch off the light /
move the blinds down. − Press the right arrow button.
... activate / deactivate the
automatic mode. − Press the Automatic button. The automatic mode cannot be activated if no
times are saved.
... reset the timer to factory
settings. − Press and hold the Reset button and the
AUTO button simultaneously for longer
than ten seconds.
A countdown starts in the display.
... display the time continuously. − Tap and hold OK and Reset buttons
simultaneously for ten seconds.
Pressing again switches off the display two
minutes after the buttons were pressed.
... save the current time as
travel time. − Press and hold the desired arrow button
and OK for more than one second.
The time is saved for Mon – Sun, and the display
shows SAVE.
... activate / deactivate the lock
function. − Press and hold the right button for longer
than four seconds.
The display shows LOCK.
Alternatively, activate the lock function in the
menu with the Lock selection.
... deactivate the lock function. − Press the right arrow button briefly.
... change the programming. − Press the Programming / Settings Menu
button.
− Confirm the programming by pressing
the OK button.
Using blind inserts, 2 movement times can be
programmed for each week block (Mon – Fri;
Sat – Sun). Using switching and dimming inserts,
4 switching times can be programmed for each
week block (Mon – Fri; Sat – Sun).
... change the time. − Tap the Programming button and then
any of the arrow buttons until the display
shows “Set”.
− Confirm by pressing the OK button and
then make the settings.
− Confirm the new time by pressing the OK
button.
In the event of power failure, the time is
maintained for at least four hours.
... operate the timer on a
different insert with the same
function. − Attach the timer to a different insert. Saved settings and switching times are retained.
... operate the timer on an
insert with a different function. − Tap and hold the left and right arrow
buttons simultaneously for longer than
20 seconds.
− Then tap and hold the left and right
arrow buttons simultaneously for longer
than 4 seconds.
A factory reset must be performed first to delete
all saved settings. Then the timer can be operat-
ed on a different insert with a different function.