Art. No. 5071 TSM
Art. No. 5072 TSM
Art. No. 5073 TSM
Art. No. 5074 TSM
2.3 Fitting and electrical connection
Installing the push button sensor and connecting it
2x (20)
2x (23)
(17)
(18)
(21)
(22)
(23)
(19)
(20)
Figure 5: Installing the push-button module
(17) Supporting frame
(18) Design frame
(19) Button sensor module
(20) Fastening screws
(21) Design control surfaces
(22) KNX connection terminal
(23) Box screws
o
Mount supporting frame (17) in the right orientation on an appliance box. Note the
TOP
marking. Use the enclosed box screws (23).
o
Position the decorative frame (18) on the supporting frame.
o
Connect the push button module (19) with KNX connection terminal (22), which is
connected to the KNX bus line, on the rear side of the module. Run the connection cable
downwards from the push button module and then into the accessory socket from the rear.
o
Attach the push button module onto the supporting frame.
o
Fasten push button module to supporting frame using the enclosed plastic screws (20).
Tighten the plastic screws only lightly.
o
Before mounting the control surfaces (21), load the physical address into the device (see
page 9-10).
Page 8 of 39
Installation, electrical connection and operation
