13 Controller
96
Controller 2
Configuration
Controller type:
Pulse lengths
Controller actual value
1
:
Main value
Stroke retransmission
1
:
No signal
Additive disturbance
1
:
No signal
Multiplicative disturbance
1
:
No signal
Min./max. contact:
Max. contact
Inactive/active contact:
Active contact
HOLD mode
0 %
HOLD output:
0 %
Error:
0 %
Alarm control:
Off
Parameter set 1
Min. setpoint:
As required
Max. setpoint:
As required
Setpoint:
8.50 pH
Proportional range:
As required
Reset time:
As required
Rate time:
As required
Period time:
As required
Output limit:
As required
Min. turn-on time:
As required
Alarm tolerance:
As required
Alarm delay:
As required
Configuration of binary output, e.g. relay)
Binary outputs
Binary output 1
Signal source:
Controller 1 output 1
Binary output 2
Signal source:
Controller 2 output 1
1
This parameter only appears if "Separate controllers" has been configured
in special controller functions.
Summary of Contents for dTRANS pH 02
