JUMO dTRANS pH 02, Operating Manual, Page: 119 / 136

119
18 Appendix
18.2 Parameters of the User level
When there are numerous device parameters to configure, it is advisable to
make a note in the table below of all the parameters to be changed and to
work through these parameters in the given order.
The following list shows the maximum number of parameters that can be
modified.
Some of these parameters will not be visible (and therefore not editable) for
your particular device, depending on the configuration.
Parameter Selection/value range
Factory setting New setting
Input pH/redox
Zero point
5.00 to 7.00 to 9.00 or
-9999.99 to 0.00 to +9999.99 mV
Slope - acidic xx.xx to xx.xx to xx.xx %
Slope - alkaline xx.xx to xx.xx to xx.xx %
Temperature
compensation source Temperature input
Option input 1
Option input 2
Option input 3
Manual temperature input
Monitoring of the
reference electrode Off
On
Glass electrode
monitoring Off
On
Filter time constant 0.0 to 2.0 to 25.0 seconds
Calibration interval 0 to 99 days (0 = timer not active)
Differential measurement Off
Main input - (minus) Option input 1
Main input - (minus) Option input 2
Main input - (minus) Option input 3
Option input 1 - (minus) Main input
Option input 2 - (minus) Main input
Option input 3 - (minus) Main input
Supply frequency 50 Hz
60 Hz
Temperature input
Temperature sensor
No sensor
Pt100
Pt1000
Cust. specs.
0 to 20 mA
4 to 20 mA
0 to 10 V
2 to 10 V
Resistance transmitter