JUMO AQUIS touch S 202581, Installation Instructions Manual

Page: 115 / 130

115
9 Retrofitting optional boards
9.2.1 Monitoring the internal temperature
The temperature inside the device can be monitored in the Device Info menu.
To do so requires corresponding user rights. The factory settings authorize the
"Master" and "Service" users for this.
Open the board temperature display:
Device Menu > Service > Service Data > "Internal Data" tab
If the inside of the device becomes overheated, the "Internal temperature too
high" alarm is triggered. The signal for this alarm is accessible in the binary se-
lection and can be used to send a signal from the device to external indicating
instruments or control rooms.
Selecting the "Internal temperature too high" alarm during configuration of bina-
ry outputs and internal functions:
Binary Selection > Alarm and Internal Signals > Internal temp. too high
9.2.2 Installing the JUMO PC setup program
Hardware and software requirements
A PC satisfying the following requirements is necessary for installation and op-
eration of the JUMO PC setup program:
•
Operating system: Microsoft®
1
Windows XP®
1
, Windows Vista®
1
or
Windows 7®
1
(32-bit and 64-bit versions)
• Memory: 1 GB
• Available hard disk space: 1 GB
• DVD drive
• USB host interface
• LAN interface (Ethernet)
1.Microsoft, Windows XP, Windows Vista and Windows 7 are registered trademarks of
Microsoft Corporation.
NOTE!
If Microsoft®
1
Windows®
1
is already running, all Windows programs must be
closed before installing the JUMO PC setup program.