JUMO 00725428, Operating Manual, Page: 21 / 36

21
6 Functions
6.3 Teach functions
The teach functions can be used to transfer certain commands to the sensor.
Teach functions in the area of "General parameters"
Teach functions in the area of "Fine adjustment"
Teach functions in the area of "Service information"
NOTE!
After executing a teach function, the data may have to be exported from the sensor again in certain cir-
cumstances.
Teach function Description
Reset to default settings All parameters under "General parameters", "Switching points",
"Fine adjustment" and "Event settings" are reset to the default
settings.
The parameters under "Service information" stay the same.
Teach function Description
Set actual start value The current measured value is adopted as the actual start val-
ue.
Set actual end value The current measured value is adopted as the actual end value.
Teach function Description
Reset all All parameters under "Service information" are reset to the de-
fault settings.
Reset operating hours counter The operating hours counter is reset to the default settings.
Reset drag indicator min. The stored minimum value is reset to the default settings.
Reset drag indicator max. The stored maximum value is reset to the default settings.