JUMO 00725428, Operating Manual, Page: 14 / 36

14
5 Configuration
5 Configuration
Starting up the IO-Link master and configuration tool
If you are using a conventional IO-Link master, you must complete the following steps to configure the
sensor.
1. Start up the hardware and software for the IO-Link master
2. Load the sensor's device description file (IODD)
a) Open the website www.jumo.de (change the language to English if necessary)
b) Use the search function to select the sensor
c) Under "Software", download the ZIP file containing the collection of IODDs
d) Extract all files from the ZIP folder
3. Start the configuation tool
4. Update the device catalog (import the IODD; localize using the "device ID" on the nameplate or the
text file in the IODD collection)
5. Create a new project
6. Establish a connection
7. Configure, extract, monitor, etc., the sensor
Instead of the manufacturer's website, you can also use the address: http://ioddfinder.io-link.com.
Configuration tool (overview)
Depending on the configuration tool, the menu structure contains different areas. The typical structure is
listed below:
•
Identification and information
These areas show information on the manufacturer and device as well as general information.
• Parameters
This section is used to configure the device.
–
General parameters
– Switching points  chapter 6.1 "Switching points", Page 15
– Fine adjustment  chapter 6.2 "Fine adjustment", Page 19
– Event settings  chapter 6.4 "Fault signaling", Page 22
– Versions
– Service information
• Monitoring
In this area process data can be extracted (snapshot).
• Diagnosis and events
These areas show diagnostic data and information about events.
• Process data
This area shows the current process data, which is extracted cyclically.