– 53 –
Error
Code
Error description
Fault Cause
Solution
E227
The file transfer failed
1. The screen cable interface is
loose or disconnected
2. The screen or motherboard pro-
gram is too old
3. Screen or motherboard hardware
failure
4. The screen line is tied with a
strong interference source
1. Check the screen line
2. Upgrade the latest screen or mother-
board program
3. Test whether you can upgrade the
motherboard program; test whether the
communication is normal in the "Test
Transmission" interface, and replace
the hardware if it is abnormal
4. Separate screen wires from strong
interference wires such as motor power
wires
E228 Data outside the range
The current graphic file data exceeds
the maximum format limit
Check if the graphic data is abnormal
E229
The modified Angle is too
large
Single modification of graph angle
value is too large
Decrease the modified angle value
E230 Loading graph data...
Processing necessary graphics data
Wait for a while before proceeding
E231 Foot follow error
1. The presser foot motor is stuck
when it rotates.
2. Parameter setting error
1. Check if the presser foot motor is nor
-
mal
2. Reset parameters
E232 No U disk!
1. U disk is not inserted or damaged
2. The screen U disk interface is
damaged
1. Re insert U disk or replace U disk
2. Insert other U disk interface or change
screen
E233 File error!
An error occurred while reading or
writing from the USB flash drive
1. Replace graphics files
2. Re insert U disk or replace U disk
E234
Graph or head offset out of
bounds!
1. The file size is too large to exceed
the processable range
2. The file is small but offset from the
processable range
3. Head offset is out of bounds
4. The parameters are set incorrect-
ly, such as the size of the pressure
plate
1. Replace graphics with smaller height
and width
2. Reset the reference point position
3.Reset the head offset value of head 2 or
head 3.
4. Set the platen size corresponding to the
machine
E235
This is not a working file!
File content or format error
Replace Recognizable Graphics File
E236
TF RAM error
Bad motherboard
Replace the motherboard
E237 Please set the admin pass-
word first
No administrative password is set
Need to set an administrative password
first
E238 Editing is not supported
No editing instructions or files
No editing instructions or files
E239 Please contact the manu-
facturer
Contact the manufacturer
Contact equipment manufacturer
E240
Communication fault 2
1. Bad communication or damage to
the screen leads to CAN commu
-
nication failure
2. The screen or motherboard pro-
gram is too old
3. The screen or motherboard is
broken
1. Check the screen line
2. Upgrade the latest screen or mother-
board program
3. Replace the screen or motherboard
E241 Time anomaly
Time is wrong
1. The time is illegally modified
2. The motherboard battery is low.
