– 30 –
4-18. Making a template
(1) Machining a template
6045 type template of dimensions of the maximum sewing range
・
Material of template: PVC plate
・
Template thickness: 2 mm thick PVC plate
・
Adjust the template size according to the cloths and/or pattern to be sewn.
The size must not exceed the maximum dimensions of the relevant specifications.
・
Check complexity of the pattern to be sewn. Then, select the sewing slits from the range of 6 mm to 8 mm
according to the complexity of the pattern.
・
Locus of sewing slits on the template should be designed according to the pattern to be sewn or intended
machining.
・
Select the suitable pattern carving machine. The template must be machined by the qualified engineers
who have successfully finished the on-the-job training.
・
After the completion of machining upper and lower templates, deburr the templates and the top surface of
the template mounting plate.
X-direction sewing range 600
Y
-direction sewing range 450
Slit width 8
Slit width 8
ø3 Milling path
Technical requirements
1. There is neither burrs nor acute edges at rims of the
template.
2. Determine the slit width within the range of 6 to 10 mm
according to the pattern template. It is normally set to 8 mm.
3. This figure only applies to the sewing machine that has a
sewing range of 600 x 450 (mm).
Position to which an
electronic label is attached
