FX-3R Maintenance
Guide
8-10
8-2-3. Adjusting the Speed Controller of the Drive Cylinder
The following describes how to adjust the up speed of the
drive cylinder.
Rev. 1.00
1) Detach the drive cylinders to be adjusted from the
driver bracket.
2)
Connect the air tube and connector.
3) Supply the main compressed air and turn on the
power.
4)
Using the manual control, operate all drive cylinders
continuously, the speed controller of which needs to
be adjusted.
5) Adjust the speed controller of the cylinder to be
adjusted visually so that the movement of the cylinder
is the same as that of other cylinders.
6)
Tighten the nut of the speed controller firmly. After the
nut has been secured, recheck that the cylinder
functions correctly.
Figure 8-2-3-1 Speed Controller of
Drive Cylinder
Speed controller
7)
Reassemble the components in the reverse order of
disassembly.
8-2-4. Replacing the Feeder Bank Board (Optional)
1)
Disconnect the connector bracket IF cable, connector bracket PWR cable.
2)
Remove the mounting screws to detach the connector bracket.
3)
Disconnect the connectors from the feeder bank board.
4)
To detach the feeder bank board, remove eight round head screws. After relevant board has
been detached, replace it with a new one.
5)
Reassemble the components in the reverse order of disassembly.
Connector bracket
E86157150A0
Feeder bank board
assembly
SM4860601SC
Round head screw
M2.6
×
6
Figure 8-2-4-1 Feeder Bank Board Related Part Names