FX-3R Maintenance Guide
13-45
13-7-3-2. Setting the Stepping Motor Driver for Support Table/Auto Width Adjustment
<Adjustment Procedure for Machines not Applicable to EN>
c
Set the rotary switches to the values in the table below.
Rev. 1.00
Switch
Settings
STOP (For support table)
STOP (For auto width adjustment)
9
5
RUN C
M1 0
Rotate the rotary
switch so that the
arrow points to the
STOP
RUN
L/HV
C.D
2/1CK
TEST
M1
d
Set the DIP switches to the values in the
table below.
No. Switch
Settings
1 TEST
OFF
2 2/1CK
OFF
3 C.D
OFF
4 L/HV
ON
Figure 13-7-3-2-2 DIP SW
Switch lever positions
When the switch is flipped down, it is
turned ON. On the contrary, when the
switch is flipped up, it is turned OFF.
Figure 13-7-3-2-1 DIP SW