FX-3R Maintenance Guide
15-13
15-5. Grease up
Use Alvania grease for all grease up locations.
1) Apply the grease to areas of 10 mm from both ends of the polished surface on the bottom of
the upper blade (See the figure below).
2) After the upper blade has been assembled, apply the grease to areas of 10 mm from both
ends of the bottom cutter blades L and R (see the figure below) and fill the holes A and B with
the grease.
3) Open and close the cutter blade several times and wipe off the grease sticking to a portion
other than the sliding part.
10
40084686
Upper blade
Rear
A
B
40084687
40084688
Bottom blades L and R
Figure 15-5-1 Grease Up Locations (1)
4) Adjust the pushing pressure of the fixed blade. (See page 1 of M11_TAPE_CUTTER in the
QA table.)
5) Apply the grease to the hatched portion at the center of the bottom blade (See the figure
below). After the grease has been applied, wipe off the grease so that the thin oil coat is
seen.
∗
Open and close the cutter several times. If the oil coat lines are seen, the amount of the
applied grease is excessive. Conversely, if no oil coat lines are seen, the amount of the
applied grease is insufficient.
6) Wipe off the grease sticking to a portion other than the sliding part.
Figure 15-5-2 Grease Up Locations (2)
40084687
40084688
ボトムブレード
L
、
R
25
40084687
40084688
Bottom blades L and R
Rev. 1.00