JUKI AMS-210ENHL2210/TF10S, Instruction Manual

Page: 38 / 293

– 25 –
ENGLISH
1. PREFACE
1) Kind of sewing data handled with IP-420
II. OPERATION SECTION (WITH REGARD TO THE PANEL)
Data that are not stored in the directories above cannot be read. So, be careful.
4) CompactFlash (TM)
1) Turn the label side of the CompactFlash(TM)
to this side (place the notch of the edge to the
rear. ) and insert the part that has a small hole
into the panel.
2) After completion of setting of the media, close
the cover. By closing the cover, it is possible
to access. If the media and the cover come in
contact with each other and the cover is not
closed, check the following matters.
• Check that the media is securely pressed
until it goes no further.
• Check that the inserting direction of the
media is proper.
1. When the inserting direction is wrong, panel or media may be damaged.
2. Do not insert any item other than the CompactFlash (TM).
3. The media slot in the IP-420 accommodates to the CompactFlash (TM) of 2 GB or less.
4. The media slot in the IP-420 supports the FAT16 which is the format of the Compact-
Flash (TM). FAT32 is not supported.
5. Be sure to use the CompactFlash (TM) which is formatted with IP-420. For the formatting pro-
cedure of the CompactFlash (TM), see "II-4-19. Performing formatting of the media", p.92.
Media
■
Inserting the CompactFlash (TM)
Pattern name Description
Users' pattern Pattern that can be stored in the body.
Max. 999 patterns can be registered.
2) Folder structure of the media
Store each fi le in the directories below of the media.
Media drive
Vector format data :
Store in ¥VDATA.
VDATA
Store vector format data.
VD00 . VDT
VD00 . VDT