JUKI AMS-210ENHL2210/TF10S, Instruction Manual

Page: 136 / 293

– 123 –
ENGLISH
3) Loosen two lower knife setscrews
❻
to adjust clearance C to 0.1 to 0.2 mm.
After the adjustment, tighten lower knife setscrews
❻
and attempt to trim spun thread 60 by the top
end of knife
❼
.
* If the thread cannot be trimmed, increase clearance C .
4) After the adjustment, assemble fi xing guide
❺
with fi xing guide setscrew
❹
.
1. The contact pressure between the upper and lower knives will be increased by widening
clearance C. Do not increase clearance C to 0.2 mm or more since the excessive contact
pressure can cause a nicked edge of the knives.
2. Securely tighten lower knife setscrew
❻
. If not, the sharpness of the knife will be adverse-
ly affected. In addition, the tape will be clogged if the screw head protrudes the guide.
❶
❷
WARNING :
1. In order to prevent accidents due to abrupt start of the sewing machine, be sure to turn OFF the
power supply and air supply after having set the tape width at the minimum value. Then, carry out
the adjustment of the knife.
2. Do not place fi ngers between the upper and lower knives to prevent injury.
1) Turn the power ON. Keep tape edit but-
ton
❶
held pressed until the data
edit screen appears.
Press tape width setting button
❷
to set the tape width at "10 mm".
2) Remove tape clamp spring
❸
Remove fi xing
guide setscrew
❹
Then, remove fi xing guide
❺
.
1-14.
How to adjust the knife
❹
❸
❼
❻
❻
C
❺