JUKI AMS-210ENHL2210/TF10S, Instruction Manual

Page: 138 / 293

– 125 –
ENGLISH
(1) Location where exclusive grease is provided
Two different types of JUKI Grease A
❶
and B
❷
and an exclusive coupling and setscrew for JUKI
Grease B are provided at the location as shown in the illustration. Add grease periodically (when
the grease runout warning No. E220 is displayed on the panel or once a year) to points to be ap-
plied with grease.
If grease has decreased due to cleaning of the sewing machine or any other reasons, be sure to
immediately add grease.
Do not use Grease A and Grease B with mixed. Be sure to use the speci fi ed grease without
fail. The grease fi lling coupling and setscrew should be used when applying JUKI Grease B.
They should not be used for JUKI Grease A.
Spare parts No.
JUKI Grease A 10g tube 40006323
100g tube 23640204
JUKI Grease B 10g tube 40013640
❶
When the grease runs short, be sure to purchase new grease.
JUKI Grease A
❶
JUKI Grease B
❷
(2) Points to be applied with JUKI Grease A
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start
or the sewing machine. In addition, attach the covers which have been removed before operation
back in place.
Use grease tube A (part number: 40006323) (in light blue) supplied with the unit for adding
grease to any points other than the points speci
fi ed below. If any grease other than the
speci fi ed one is used, the related components can be damaged.
■
Adding grease to the oscillating rock shaft gear section
1) Tilt the sewing machine and remove grease cover
❶
.
2) Apply JUKI Grease A onto the gear section of oscil-
lating rock shaft and the periphery of the hook driving
shaft.
3) Apply JUKI Grease A also onto the felt surface of
grease cover
❶
.
If the grease
has decreased
due to clean-
ing, air blow or
other reasons,
apply grease
again without
exceptions.