JUKI AMS-210ENHL2210/TF10S, Instruction Manual

Page: 109 / 293

– 96 –
No. Item Setting range Edit unit
Number of stitches
of thread clamp release is set. 1 to 7 1
Clamping timing
of thread clamp can be delayed. – 10 to 0 1
Thread clamp control can be prohibited. --- ---
Normal Prohibited
Feed motion timing is selected.
Set the timing in “–” direction when stitch is not
well-tightened.
– 8 to 16 1
Origin retrieval can be performed every time after end of
sewing --- ---
Without origin retrieval With origin retrieval
Needle stop position is set. --- ---
UP position Upper dead point
Thread trimming can be prohibited. --- ---
Normal Thread trimming
prohibited
Route of return to origin by return to origin button can be selected.
--- ---
Linear return
Reverse return of
pattern
Origin retrieval
→
Sewing start point
Bobbin winding speed can be set. 800 to 2000 100 sti/min
Motion method of wiper can be selected. --- ---
Invalid
Magnet typewiper
Thread tension output time when setting
thread tension can be set. 0 to 20 1
Bend position of thread clamp is selected.
1 : H type thin thread (#50 to #8)
2 : H type intermediate
3 : H type thick thread (#20 to #5)
--- ---
Thread clamp and thread clamp position selection --- ---
Front position Rear position