JR X9503 2.4, Instruction And Programming Manual

Page: 70 / 107

System Mode
System Mode
Model Reset Pg. S-7
Type Select Pg. S-6
Info Display
Model Select Pg. S-3
Model Name Pg. S-6
Transfer Pg. S-8
Trim Step Pg. S-10
Device Select Pg. S-11
Wing Type Pg. S-15
Model Select
S-2
S-3
System mode is the foundational programming. The
screens include model name, model reset, modulation,
data transfer, etc.—functions you typically set once and
seldom change.
To enter System Mode:
Press ENT and hold while turning on the transmitter.
The screen should appear as follows.
System mode contains the following screens:
Model select allows you to store and select up to 50
different models.
Note : When you set up a new model, select an
unused model memory. If you select a current model
memory, reset the model to factory default settings
before programming the new model. See model reset
page S-7.
1. In the SYSTEM Menu , highlight and select Model SEL
using the Selector .
2. Use the Selector to highlight and select the desired
model number.
3. Press the LIST button to return to the SYSTEM Menu.
TX 10.5v MODEL 1
Integ. 1:29
0 0 0
DISP
CONT
Select 49 HELI
50 HELI
MODEL 1 MODEL 1 GLID
2 ACRO
3 GLID
[Model SEL]
MODEL 1 GLID <ZENITH >
[MDL Name]
[Type SEL] MODEL 1 GLID
GLID ACRO HELI
[Type SEL] MODEL 1 GLID
LST
NO
YES
MODEL 1 GLID
Are you sure? Y/N
[TRANSFER]
RECEIVE
MODEL 2 GLID
MODEL 1
Connect DSC & POWER off
[TRIM STEP]
SPOI 100%
AILE 4
ELEV 4
RUDD 4
FPRN 4
FLAP 4
[Devic. SEL]
SPEED LAUN
INH INH
MOTO FLAP AUX2 AUX3 AUX4
BTFL FLAP SPOI AUX3 AUX4
SW LEV STK LEV SW
OUT: INH ACT ACT INH ACT
LST
[WING TYPE]
V-tail:
INH
DUAL FLAP
INH