WING Parameter – (Wing Type)
WING Parameter – (Wing Type) (continued)
A-12
A-13
1. Highlight and select
Wing TYPE
in the
SYSTEM
Menu
using the
Selector
.
2. If only the Aileron channel is to control both Ailerons,
either with a single servo or with 2 servos connected
together via a Y-harness, then leave the Wing
3. If you will use 2 channels to control the Ailerons and
the aircraft does not have separate flaps, highlight and
select
Wing
with the
Selector
and then highlight
and select
FLAPERON
as the wing type. Plug the
right Aileron into the Aileron channel (Ch2) and plug
the left Aileron servo into the FLAP or AUX1 channel
(Ch6) of the receiver.
parameter set to the default of
NORMAL
and plug
the Aileron servo into the Aileron channel (Ch2) of the
receiver. Also use
NORMAL
if the aircraft has flaps
that are separate from the ailerons.
Note
: If not using Ailerons as flaps, inhibit the FLAP
Switch and FLAP TRIM in the
Devic.SEL
function
in the
SYSTEM Menu
. This eliminates having a
severe out-of-trim condition if the FLAP Switch or
FLAP TRIM is accidentally moved.
4. If the aircraft is a Delta wing configuration, highlight
and select
Wing
using the
Selector
, then highlight
and select
DELTA
as the wing type. Plug the right
Aileron into the Aileron channel (Ch2) and plug the left
Aileron into the Elevator channel (Ch3) of the receiver.
Note
: To properly set the servo direction when
using the delta wing setting, begin by using servo
reversing on each channel as necessary to get the
ailerons to move the proper direction with aileron
stick movement. If the ailerons move the incorrect
direction with elevator stick movement, swap the
channels that the servos are plugged into the
receiver to reverse them.
Summary of Contents for X9503 2.4
Page 43: ...A 56...
Page 103: ...S 68...
