Delay (Flap System)
ELE
FLP M – ELEVATOR-TO-FLAP MIXING
A-30
A-31
The Delay parameter determines how long it takes for
the flaps and Elevator to reach their positions. The
X9503 2.4 automatically times the Flaps and Elevator so
they reach their positions at the same time. This allows
smooth Flap deployment and retraction. You can adjust
the Delay in .1-second increments up to a maximum of 2
seconds.
1. Highlight and select
Delay
in the
Flap System
display using the
Selector
. Then use the rotary to
select a delay between .1 second and 2.0 seconds.
The X9503 2.4 features a built-in mixer for Elevator-to-
Flap. The mixer causes the Flaps (or Flaperons) to move
when the Elevator is moved, resulting in tighter looping
maneuvers, or to provide some Aileron reflex for some 3D
maneuvers such as harriers. Typically, the flaps are set to
travel downward with up Elevator and upward with down
Elevator. The exception is adding reflex for 3D maneuvers
such as harriers. In this case the reverse is set so the
flaps travel up with up elevator and down with down
elevator. You can change the direction the flaps travel with
Elevator input using positive and negative values.
If Elevator-to-Flap mixing is desired for the aircraft,
perform the steps below.
1. Highlight and select
ELE
FLP M
in the
FUNC.LIST
to obtain the Elevator-to-Flap mix display.
2. There are 2 sets of mixing values available – Pos0 or
Pos1. If the Pos0 values are left at 0% then the mixer
may be turned on and off – Pos0 will be OFF and Pos1
will be ON (this can be reversed by leaving the Pos1
values at zero and putting values in Pos0). Highlight
and select
DN
next to Pos1 and set the value to give
the desired amount of Flap travel in the Down direction
when full Up Elevator is applied.
3. Highlight and select
UP
next to Pos1 and set the value
to give the desired amount of Flap travel in the UP
direction when full Down Elevator is applied.
4. Scroll down to the bottom line of the display to select
the Flight Mode(s) and/or switch(es) used to turn
the mixer on and off. You can also turn the mixer on
and off with the throttle by highlighting and selecting
THRO STK
. Set the percentage of throttle to the point
where the mixer is to switch between on and off.
Note
: Pos1 always has priority over Pos0. If multiple
switches are selected to turn the mixer on and off
and one of the switches is in its Pos1 position, all
other switches are ignored and the Pos1 values are
in effect.
Summary of Contents for X9503 2.4
Page 43: ...A 56...
Page 103: ...S 68...
