Jonix 70MATEWHITE, Use And Maintenance Manual

Page: 15 / 48

15
JO NIX
mate
01
02
The
JO NIX
mate
device leaves the factory fully wired. It only needs to be plugged into the
electric mains, 230V/ ~1 / 50Hz + PE. The unit is provided with power cord with Schuko plug.
The user has to provide a differential circuit breaker upstream in compliance with current norms.
The socket on the rear panel is equipped with a fuse.
7.5 ELECTRIC POWER SUPPLY
Before making any connections, make sure the mains voltage complies with what
is shown on the label.
The ON/OFF switch (placed next to the power supply socket on the front panel), indicates when
the device is powered.
WARNING!
it will take some minutes for the display to load the software correctly. When the
device is turned on the display might appear to be turned off.
Fig. 01: Connect the device to the mains
using the power cable provided.
Fig. 02: Once connected to the mains
supply, the
JO NIX
mate
module is ready
to work. In order to turn on the device act
on the red switch 0/I (present on the upper
rear panel) turning it to I.
7.6 USING THE DEVICE
The control and the setting of functions is set using the Display (see chap. "Technical
Data" and "User interface and menu navigation".
Air flow rate (m
3
/h) No. of ionising modules on
2000 2
The module is set with the following
default parameters:
7.7 DEFAULT SETTINGS
ATTENTION!
Use the cable supplied for connection to the mains or use one with the same
section always made up of F, N and T.