9
10
Fold Travel Cot
see images
8
-
13
1. Remove the mattress.
8
2. Pull the folding webbing upward.
9 10
!
Do not unlock rails yet. Center of floor must be halfway up before rails will unlock.
3. Unlock all four rails by following these steps.
1) Slightly lift the center of the rails.
11
2) Squeeze the latch button on the rail to release the two tubes.
11
!
Do not force fold.
!
Both tubes must be released for the rail to fold, if rail does not fold completely, please lift the
center of floor higher, and then try again from step 3.
4. Fold the unit, but do not force.
12
!
If unit will not fold, look for a partially latched rail. Squeeze the latch button to release the rail.
5. Wrap the travel cot with the mattress. Guide the hook and loop fasteners through the rings
and attach them.
13
Cover Travel Cot
see images
14
-
15
Cover the travel cot by following these steps.
1. Place the mattress, with handle facing the zipper on the carry bag.
2. Cover unit with carry bag
14
, and then zip together.
15
3. Pull the handle out from carry bag. The carry bag and the travel cot will be lifted together.
CO-SLEEPING MODE (FIXING TO THE BED)
see images
16
-
21
The travel cot can be fixed to the parent’s bed (co-sleeping mode).
!
IMPORTANT FOR THE SAFETY OF YOUR CHILD: this method is only possible with bed types that comply
with all of the conditions described in this paragraph.
Press both buttons
16
- 1
to drop the side down
16
- 2
. Position next to bed
17
, Connect Buckle to Kubbie
Sleep
18
then loop strap around bed frame and connect to adjuster buckle
19
, then pull straps tight
20
. Ensure
gap between mattress and side of Kubbie Sleep is sufficient
21
, max gap of 2cm.
In particular the side support of the travel cot should always be put close to the parent’s mattress and the
parent's mattress should always be higher than or the same as the height of the side support for restraint of the
travel cot.
21
!
Check to make sure that the travel cot in the co-sleeping mode does not interfere with the parent’s bed.
!
During use, make sure that the parents bed sheets, blankets etc. do not enter and cover the interior of the
travel cot.
Bassinet Assembly
see images
22
-
25
Tip
Before setting up bassinet, make sure all rails have become rigid.
1. Zip up the bassinet and secure the zipper head with buckle, then cover it with flap.
22
!
Must zip up the bassinet completely without crevice before using.
2. Assemble the connecting tubes.
23
3. Place the mattress into the bassinet.
24
!
Place mattress, soft side up.
The installed bassinet is shown as
25
Care and Maintenance
1. The covering material is not removable.
2. Your travel cot can be spot cleaned with a sponge and soapy water.
3. Do not use undiluted neutral detergent, gasoline or other organic solvent to wash the travel cot.
It may cause damage to the travel cot.
4. To wash carry bag, machine wash in lukewarm water and drip-dry. Do not use bleach.
5. At the beach or in the garden, clean sand and grit off your travel cot. Sand in the long rail locks
may cause damage.
6. From time to time, check your travel cot for worn parts, torn material or stitching. Replace or repair
the parts as needed.
7. If the travel cot is not in use for a long period of time, please put it in the shade where your child
cannot access it.
