Johnson Controls York AYK550, User Manual

Page: 90 / 279

2
YORK, A Johnson Controls Company
$
2FF_==`=
This group defines ramps that control the rate of acceleration and deceleration. You define these ramps
as a pair, one for acceleration and one for deceleration. You can define two pairs of ramps and use a
digital input to select one or the other pair.
2FF_==`=
23 =,2 ! 7 !2,2 4, #
2201
``F#" ^g
Defines control for selection of acceleration/deceleration ramps.
• Ramps are defined in pairs, one eAYK for acceleration and deceleration.
• See below for the ramp definition parameters.
0 =
NOT SEL
– Disables selection, the first ramp pair is used.
1 =
DI
1 – Defines digital input
DI
1 as the control for ramp pair selection.
• Activating the digital input selects ramp pair 2.
• De-activating the digital input selects ramp pair 1.
2…6 =
DI
2…
DI
6 – Defines digital input
DI
2…
DI
6 as the control for ramp pair selection.
• See
DI
1 above.
7 =
COMM
– Defines serial communication as the control for ramp pair selection.
-1 =
DI
1(
INV
) – Defines an inverted digital input
DI
1 as the control for ramp pair selection.
• De-activating the digital input selects ramp pair 2
• Activating the digital input selects ramp pair 1.
-2…-6 =
DI
2(
INV
)…
DI
6(
INV
) – Defines an inverted digital input
DI
2…
DI
6 as the control for ramp pair selection.
• See
DI
1(
INV
) above.
2202
"!'* >c> > Q>
Sets the acceleration time for zero to maximum frequency for ramp pair 1. See A in figure.
• Actual acceleration time also depends on 2204
RAMP SHAPE
.
• See 2008
MAXIMUM FREQUENCY
.
2203
"!'* >c> > Q>
Sets the deceleration time for maximum frequency to zero for ramp pair 1.
• Actual deceleration time also depends on 2204
RAMP SHAPE
.
• See 2008
MAXIMUM FREQUENCY
.
2204
!%#% >>>> > >
Selects the shape of the acceleration/deceleration ramp for ramp pair 1. See B in
figure.
• Shape is defined as a ramp, unless additional time is specified here to reach
the maximum frequency. A longer time provides a softer transition at eAYK end
of the slope. The shape becomes an s-curve.
• Rule of thumb: 1/5 is a suitable relation between the ramp shape time and the
acceleration ramp time.
0.0 =
LINEAR
– Specifies linear acceleration/deceleration ramps for ramp pair 1.
0.1…1000.0 =
S
-
CURVE
– Specifies s-curve acceleration/deceleration ramps for
ramp pair 1.
2205
"!'*F >c> > ^>
Sets the acceleration time (s) for zero to maximum frequency for ramp pair 2. See 2002
ACCELER TIME
1.
2206
"!'*F >c> > ^>
Sets the deceleration time for maximum frequency to zero for ramp pair 2. See 2003
DECELER TIME
1.
T
FREQ
T
MAX
FREQ
Linear
S-curve
A
A = 2202
ACCELERATION TIME
B
B (=0)
B = 2204
RAMP SHAPE
MAX