Johnson Controls York AYK550, User Manual

Page: 153 / 279

2
%**8 = 9);
YORK, A Johnson Controls Company
• Fieldbus controller supplied setpoint value in the appropriate location. (As defined
in "Analog Output Control" above.)
1. BACnet not defined at time of publication.
2@@ =,2 \,
When using fieldbus control, specify the drive’s action if serial communication is lost.
\3;=W42@,9h\J
%34 3\3;=W
Inputs to the controller (drive outputs) have pre-defined meanings established by the
protocol. This feedback does not require drive configuration. The following table lists
a sample of feedback data. For a complete listing, see input word/point/object
listings in the technical data for the appropriate protocol starting on page 152.
1. BACnet not defined at time of publication.
2,8
With Modbus, any parameter can be accessed using the format: 4 followed by
the parameter number.
%@, #,, 7
%2,2=2!4 =
23; F \" J ,
4010
SETPOINT
SEL
8 (
COMM VALUE
1)
9 (
COMM
+
AI
1)
10 (
COMM
*
AI
1)
Setpoint is 0135
value (plus or
times AI1) See "Analog Output Control".
%@, =,2
%2,2=2
!4 =
3018
COMM FAULT FUNC
0 (
NOT SEL
)
1 (
FAULT
)
2 (
CONST SP
7)
3 (
LAST SPEED
)
Set for appropriate drive response. –
3019
COMM FAULT TIME
Set time delay before acting on a communication loss. –
%@,
%2,2=2!4 =
23; F \" J ,
0102 SPEED 40102 AI3 5
0103 FREQ OUTPUT 40103 AI1 2
0104 CURRENT 40104 AI4 6
0105 TORQUE 40105 AI5 7
0106 POWER 40106 AI6 8
0107 DC BUS VOLT 40107 AI11 13
0109 OUTPUT VOLTAGE 40109 AI12 14
0301 FB STATUS WORD – bit 0 (STOP) 40301 bit 0 BI1 23
0301 FB STATUS WORD – bit 2 (REV) 40301 bit 2 BI2 21
0118 DI1-3 STATUS – bit 1 (DI3) 40118 BI12 72