YORK, A Johnson Controls Company
$
The Start-Up Assistant will guide you through the start-up.
The Start-Up Assistant guides you through the basic programming of a new drive.
(You should familiarize yourself with basic control panel operation and follow the
steps outlined above.) At the first start, the drive automatically suggests entering the
first task, Language Select.The assistant also checks the values entered to prevent
entries that are out of range.
The Start-Up Assistant is divided into tasks. You may activate the tasks one after the
other, as the Start-Up Assistant suggests, or independently.
2,8
If you want to set the parameters independently, use the Parameters mode.
The order of tasks presented by the Start-up Assistant depends on your entries. The
following task list is typical.
]
Change the values suggested by the
assistant to your preferences and then
press SAVE after every change.
'W @
=,2
Spin the motor
• Prompts for control panel display language selection.
• Prompts for motor data.
• Guides user through rotation check.
Commission drive
Prompts for motor data.
Application
Prompts for application macro selection.
References 1 & 2
• Prompts for the source of speed references 1 and 2.
• Prompts for reference limits.
• Prompts for frequency (or speed) limits.
Start/Stop Control
• Prompts for the source for start and stop commands.
• Prompts for start and stop mode definition.
• Prompts for acceleration and deceleration times.
Protections
• Prompts for current and torque limits.
• Prompts for the use of Run enable and Start enable signals.
• Prompts for the use of emergency stop.
• Prompts for Fault function selection.
• Prompts for Auto reset functions selection.
Constant Speeds
• Prompts for the use of constant speeds.
• Prompts for constant speed values.
PID Control
• Prompts for PID settings.
• Prompts for the source of process reference.
• Prompts for reference limits.
• Prompts for source, limits and units for the process actual value.
• Defines the use of Sleep function.
Low Noise Setup
• Prompts for switching frequency.
• Prompts for definition of Flux optimization.
• Prompts for the use of Critical speeds.
Summary of Contents for York AYK550
