Johnson Controls York AYK550, User Manual

Page: 55 / 279

$
YORK, A Johnson Controls Company
2_&, 7,
This group contains drive operating data, including actual signals. The drive sets the
values for actual signals, based on measurements or calculations. You cannot set
these values.
2_&, 7,
23 =,2 ! 7 !2,2 4, #
0102
#% Q @ @
The calculated speed of the motor (rpm).
0103
&'%'\!p >> Z > Z
The frequency (Hz) applied to the motor. (Also shown by default in OUTPUT display.)
0104
!!' >>d*
F
>
The motor current, as measured by the AYK550. (Also shown by default in OUTPUT display.)
0105
'&!p FFq >q
Output torque. Calculated value of torque on motor shaft in % of motor nominal torque.
0106
%&6! >>d% > W6
The measured motor power in kW.
0107
J#&"' F>d
3
The DC bus voltage in VDC, as measured by the AYK550.
0109
&'%'&"' F>d
3
The voltage applied to the motor.
0110
!*'% q > q
The temperature of the drive heatsink in Centigrade.
0111
m'!"!\ Q @` @`
Z > Z
External reference,
REF
1, in rpm or Hz – units determined by parameter 9904.
0112
m'!"!\F q >q
,2<_^q
External reference,
REF
2, in %.
0113
'!""&'*& F
Active control location. Alternatives are:
0 =
HAND
1 =
EXT
1
2 =
EXT
2
0114
!'*! kkkk9 9 9
The drive’s accumulated running time in hours (h).
• Can be
,
by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0115
6&'!! kkkkW69 W69
The drive’s accumulated power consumption in kilowatt hours.
• Can be
,
by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0116
%%"J"&'%' q >q
,2<_^q
Application block output signal. Value is from either:
• PFA control, if PFA Control is active, or
• Parameter 0112
EXTERNAL REF
2.