- 9 -
7. INSTALLATION INSTRUCTIONS
PLEASE TAKE THE TIME TO READ THESE INSTRUCTIONS COMPLETELY.
A QUICK CHECK OF THE CONTENTS OF THE ACCESSORY BOX WOULD
ALSO DECREASE THE INSTALLATION TIME.
Gather the tools and materials required for the installation.
Select the location best suited for your lift.
NOTE:
In determining lift area check for the following:
-
Ease of driving a vehicle on and off the lift.
-
Overhead obstructions, low ceiling height, overhead doors, overhead heaters etc.
Minimum ceiling clearance must be 12 ft. Lower ceiling heights may interfere with
servicing some vehicles
-
Floor obstructions, drains, uneven floor in lift area, work benches, electrical wiring in
floor, etc.
IMPORTANT:
It is the user’s responsibility to provide a satisfactory installation area for the
lift. Lifts should only be installed on level concrete floors with a minimum thickness of four
(4) inches or 102mm. Concrete must have a minimum compressive strength of 3500 psi
(24 MPa) and should be aged thirty (30) days prior to installation. Please consult the
architect, contractor or engineer if doubt exists as to the strength and feasibility of the floor
to enable proper lift installation and operation.
It is the
user’s responsibility to provide all wiring for electrical hook-up prior to
installation and to ensure that the electrical installation conforms to local building codes.
Where required, it is the user’s responsibility to provide an electrical isolation switch located
in close proximity to the lift that will enable emergency stop capability and isolate electrical
power from the lift for any servicing requirements.
Recommended clearance around the lift is 3 to 4 feet. Ensure clearance conforms to
local building and fire codes. Recommended overhead clearance is a minimum twelve (12)
foot ceiling providing 6 feet for the maximum lift height and 6 feet for the supported vehicle.
For vehicles taller than 6 feet it is recommended that the user provides additional overhead
clearance or a shut off mechanism to stop the lift from raising the vehicle too high.
An outline matching the dimensions shown in
Figure 3
will need to be marked on the floor.
Refer to
Figure 3
for outline dimensions. Refer to General Lift Specifications for overall lift
dimensions.
DO NOT install the lift on asphalt or other unstable surfaces. Lift columns are
supported only by anchors in floor.
INSTALLER:
PLEASE RETURN THIS BOOKLET TO LIFT OWNER/OPERATOR AFTER
COMPLETING INSTALLATION
ATTENTION!
This lift is intended for indoor installation only. It is prohibited to
install this product outdoors. Operating environment temperature range should
be 41
– 104 °F (5 – 40 °C). Failure to adhere will result in decertification, loss of
warranty, and possible damage to the equipment.
Summary of Contents for EELR369A
