- 35 -
Jack Beam Installation, Operation and Maintenance Manual
CAUTION
Before using this product, read and fully understand the operating
instructions and all decals on the product. This is necessary to
prevent injury to the operator and damage to the product.
Roll jack forward before moving vehicle on or off lift.
Do not attempt to use this jack for anything other than its intended
purpose.
If jack begins to tilt as the vehicle is raised, STOP! Lower jack and
re-position the vehicle.
Do not use this jack if it is visibly worn, distorted or damaged.
Maximum air operating pressure not exceed 150 psi.
Always wear appropriate eye protection.
WARNING
Lifting capacity of this jack is 6000lbs
(Hydraulic Pressure at Cap. = 3770 psi)
Exceeding this could result in severe personal injury or death.
When the total lifting capacity of 2 rolling jacks differs from the rated
capacity of the lift they are used on, the capacity of each jack should
not exceed 1/2 the total capacity of the runways. Exceeding this
could result in severe personal injury or death.
Lift vehicle at manufacturer’s recommended pick-up points only.
Vehicle weight must be evenly distributed on each jack lift pad.
Keep fingers and hands clear of all pinch points at all times.
Summary of Contents for EELR369A
