Coffeemar
G-250
//
Coffee
MNP116M01GBV00
Date: 09/04/2013 Rev. 1
PAGE 76 OF 95
● The compact
communicates properly and
you can enter programming
mode but no coin is
accepted.
● Prices not programmed
● Program prices .
● The compact sends all
coins to the vault.
● Change is incorrectly
programmed.
● The change tubes are
faulty.
● Maximum values
programmed for coins in
the tube have been
exceeded.
● Check coin values.
● Check where the coins
are being sent.
● Reset the fault and empty
the tubes.
● Check the maximum
number of coins that can be
in tubes.
● Coins get stuck at the
entrance of the tubes.
● Change is incorrectly
programmed.
● Separators are sticking.
● Wrong tube model for
this change combination.
● Check the compact
values.
● Send the compact to
technical support service.
● Replace the tubes.
● The compact rejects a
high percentage of coins. In
coin check, the coins
appear as unrecognised.
● Measuring channel is
dirty.
● The selector door is not
completely closed.
● Clean the selector with a
cloth moistened with
alcohol.
● Check return motor
operation. Get rid of any
other obstruction.
● The compact does not
accept any coin. When you
insert a coin no digit
appears.
● The connection cable
between the selector and
the control card is broken
or disconnected.
● Connect the cable.
● Programmed data has
been lost.
● Electric noise.
● Make sure the machine is
properly grounded.
● When reloading coins,
coins are not accepted from
tubes.
● First reloading was not
carried out properly.
● Consult first reloading
procedure in compact
manual.
● Coins with a given value
● Inhibitions wrongly
● Check general inhibitions.